More information about FLIN

With a height of only 11mm, the FLIN lock finds enough space in almost every side wall. The FLIN is drilled or milled with two 35mm diameter holes.

All versions are equipped with a 1.5 m cable. The length of the cables as well as connectors can be customized on request. For large quantities, there is also the possibility of customizing the color.

The current consumption is 100 to a maximum of 500 mA for 0.3 seconds. Once the lock has reached an end position, no more current flows. In case of voltage loss, the lock remains in the last position.

Optionally, the FLIN lock can also be manufactured with a “door closed switch”.

The lock is recommended for drawers with a maximum width of 50 cm

The FLIN lock is milled into the side panels and connected with the cable to

a SOLO or connected directly to an external voltage.

It can be used on hinged doors and also on drawers.

When used on drawers, a lateral clearance of 1.5 mm

sufficient.

 

PROPERTIES:

– adjustable locking part

– small, robust motor

– milled into the side wall

– Narrow enough for 16 mm side walls

FLIN 2.5V/ 12 V

The FLIN is operated with a voltage of 2-2.5V or 8-16V DC.

A switch or relay is used to control it.

FLIN 2,5V

– Black – GND / Minus

– Green – open

– Yellow – close

– 1.5 m cable

FLIN 12 V

– Black – GND / Minus

– Red – open

– Green – close

– 1.5 m cable

Current consumption at maximum load: 500 mA

Current consumption in normal state: 100 mA

FLIN SECONDARY

The FLIN SECONDARY lock is normally used in combination with

a SOLO Bluetooth or SOLO125 with external antenna is used

and is connected to the back of the SOLO.

Alternatively, any other microprocessor can be used to

control system can be used.

Attention: If you use the FLIN SECONDARY in

Combination with a battery-powered

use SOLO lock, it remains with a

Low battery alarm opened